12 Volt DC 500 mA Regulated Switch Mode Power Supply with 1.8 m Lead and DC Plug.

Regulated 12V power supply capable of supplying up to 500 mA. The unit has a stylish impact resistant case with LED indicator. The output is via a 1.8 m lead fitted with a 2.1 mm DC power plug, centre positive. Ideal for CCTV camera use.

Our Order Code: P003L

Our Loc:
 

1. MILLIAMP (mA): Verify the mA requirement of the unit and determine if it can be used with a 500mA adaptor.
2. POLARITY: Determine the polarity (+ or -) of the unit and set the polarity according to the polarity of the electronic unit. The polarity can be found on the unit or in the user manual.

NOTE: The positive setting (Negative ground) is the most common requirement.
 
      
 

3. PLUG IN: Attached the adaptor into a 100-240V mains socket.
4. IMPORTANT: If unit does not operate properly, check the polarity setting IMMEDIATELY.
5. Remove the unit when not in use.

1. For indoor use only.
2. If the external flexible cable is damaged, it shall be replaced by the manufacturer or his service agent or a similar person in order to avoid a hazard.
3. The socket-outlet shall be installed near the equipment and shall be easily accessible.